Products
| Type | Product code |
Maximum continuing service flow rate (lpm) | Backwash flow rate (lpm) | Minimum - maximum operating pressure (kpa) | Inlet outlet (mm - male) | Approx. shipping weight (kg) |
| Multimedia | MFM07 MFM09 MFM12 |
20 30 55 |
10 23 38 |
250 - 690 | 25 | 25 41 102 |
| Carbon | MFC07 MFC09 MFC12 |
5 9 15 |
9 16 25 |
250 - 690 | 25 | 13 17 43 |
| Neutraliser | MFN09 MFN12 |
10 18 |
16 25 |
250 - 690 | 25 | 52 67 |
| Birm | MFIB10 MFIB12 |
10 15 |
20 25 |
250 - 690 | 25 | 45 80 |
| Greensand | MFIM10 MFIM12 |
10 15 |
20 25 |
250 - 690 | 25 | 65 120 |
| Type | Product code | Operating Parameters |
| Multimedia | SAFM09 | water temp 5° - 45° water ph 5.5 - 9.0 suspended solids max 100 mg / l iron no effect oil free of hydrocarbons Note: not recommended for Colloidal Sediment removal. |
| Carbon | SAFC09 SAFC12 |
water temp 5° - 45° water ph above 5.5 suspended solids max 10 mg / l iron will effect service life oil free of hydrocarbons Note: service flow rate may need to be reduced for extended contact time. Refer IBC Water. |
| Neutraliser | SAFN09 SAFN12 |
water temp 5° - 45° water ph above 5.5 suspended solids max 50 mg / l iron max 0.5 mg / 1 oil free of hydrocarbons |
| Birm | SAFIB10 SAFIB12 |
water temp 5° - 45° water ph 6.8 - 8.8 birm, 6.2 - 8.8 manganese greensand suspended solids max 50 mg / l iron & MANGANESE max 15 mg / 1 oil free of hydrocarbons BIRM min 15% dissolved oxygen of iron level |
| Greensand |
MFIM10 |
Alkalinity should be greater than two times the combined sulfate and chloride concentration. Note: due to the complexities of iron, manganese and hydrogen sulphide it is recommended that product selection be referred to IBC Water. *intermittent peak flows of up to twice service are possible dependent on iron/manganese level for birm/greensand filters. |